Shelby,I usually use LGO to make a Rinex file for OPUS and have been able to send a raw .obs file for my system 399. Can you tell me the extension fo...

Yes, LGO version 3, I have SkiPro 3 installed and it does not have the system 1200 in it. I knew my LGO was version 3.?, just was not sure because I ...

Thanks for your quick response, as it turns out it is not always the obvious. The problem was not my memory but the keyboard on the old computer had ...

I have started to have problems myself with my GPS1200 system using OPUS. This week I did tow observations near each other, the first one processed a...

The coordinates came straight off the NGS data sheets for the monuments that we came off of.

The survey was started from two published monuments on NAD83 in feet and the water tank that we are surveying has has published coordinates on it. Th...

Yes, NAD 83 in feet, NAD 27 around here is about 100' different.

Thanks, pickfirst fixed it.

Thanks, I will.

Well I spoke to soon that fixed my line tag problem, but the curves are still starting at C3 and when I insert the table I have two curves without a c...

I found them, I am working on grid at about 500,000 and 1,500,000 and they were down at 0,0. I did a zoom extents and found them and erased and reset...

Make A New Block With the Exact Same NameThanks guys, I will try these suggestions and see which works for me.

I don't think I have ever inserted my seal in the original drawing template.

It is possible, I know a lot of blocks are created and inserted on layer 0, but I don't know why my seal would be nested.

I don't think it is in the drawing, but I think that if may have been an xref and I need to fine out how to un-bind it from the drawing. I did a bloc...