Last seen: March 18, 2026 8:45 pm
We use Garmins with wass at work extensively. Compared to RTK surveyed points I have very rarely seen them over 10?? off. Most of the time they are w...
We use range poles to elevate receivers. They can be had for less than $30 for four foot sections. Making sure it is plumb and doesn??t move too much...
Why does it have to be so scientific? It is physically impossible for two receivers to be in the exact same spot at the same time. Put a series of poi...
Jones, post: 452337, member: 10458 wrote: We pinned a house a couple of weeks ago, the head mason drove a 2017 chevy 3500 LTZ, his poor help was only ...
Mark Silver, post: 452970, member: 1087 wrote: [Snark On]How will you account for differences in constellation? One receiver starts the round at a tim...
Here is a test I would like to see.Go randomly put out 20 or so points mag nails or whatever along a trail through the woods with lots of canopy space...
Jon B. Gramm, post: 450775, member: 10309 wrote: These are just some of my opinions, and thoughts based upon a lot of experience in the seismic survey...
We mainly do seismic surveying. Yes some of it is for seismic shot holes. Sub meter in XYZ is our requirement. I have read up some on the Javad Nate a...
Well I have an update. My neighbor had me call the engineering firm to see what they could provide. They said they had a TIN and after doing some read...
JKinAK, post: 447749, member: 7219 wrote: Have the surveyors come out NOW and set RPs (reference points) for the pad corners and other key point - you...
clearcut, post: 447766, member: 297 wrote: From the OP var posts:"My neighbor is building a house right next to a lake and has to build up the pad for...
I don't have an employer I own my own business with insurance and have been operating surveying equipment for about ten years. We work in the oil indu...
Lee D, post: 447739, member: 7971 wrote: Site is balanced if no material has to be brought in or removed, just pushed around.Got it. It. think it has ...
Larry Scott, post: 447733, member: 8766 wrote: What about compaction?Just pushing it around end up with a costly mess in fill zones.Is the site balanc...
jim.cox, post: 447729, member: 93 wrote: Ideally you should be able to get the design data from the engineer - that pdf had to come from somewhere. Th...