That's a good question based on what it says on the form and the fact that it is a federal form. In NJ they are only supposed to be done by surveyors...
Can you elaborate on what you mean by checking the prism constant? Are you verifying that the manufacturer's published constant is correct? Or just th...
Actually, I spoke too soon before. I have had tight tolerances where I tried to achieve 0.005' which would be roughly 1.5mm, so I guess maybe it would...
I've never done any survey work where I'd care about the difference between 0.3mm and 2.0mm. What kind of stuff are you doing where that would make a ...
I'm guessing N&D is nail and disc and IPC is an iron pin with a cap? I prefer to set iron pins with caps. Usually around here the soil conservatio...
Do you view them through outlook or livemail? If so, you can create an archive folder to store them there....they should remain saved in there even i...
It's got to be a freeze/thaw problem. Can you set three really long hubs for the feet to sit on? What I've don't before is place the instrument over t...
I carry it the same way as foggy....unless it's a long distance or rough/slippery terrain. Then it goes in the case. I always keep it vertical though....
I have the HP T120 and I think it's pretty good. I got it on Amazon when it was on sale. I think I paid like $800 with shipping. As far as software...
have you tried PDF exchange viewer? I use that for most things. You can insert a picture with it as well, but again.....word is easier.
And why is it 8.5x14" now? Just another nuisance.....I have to start buying legal sized paper now? I use 11x17 for small surveys and rolls for big s...
Well the damn thing cracked in half again...I just ordered the nylon one you posted. I'm looking forward to see how it comes out and holds up.
Why don't they just make a word form like they did last time? I CAN fill this out as a pdf, but it would be much easier if it were word format....
I would not fault anyone for using the old form still. They need to make it obvious when they finally change it.
how come it's still not available on the official FEMA website?
imaudigger, post: 351598, member: 7286 wrote: You have CAD software don't you? Switch the line types and make some money.Back in the old days, those c...
Yea maybe the insert would help. I use lath and or hubs about 99% of the time, but for loose stuff with tons of points I tend to use flags. Most recen...
Paul D, post: 351062, member: 323 wrote: try this I feel like they would dump all over the place when you bend over with that one....