The daughter and I worked half the day. Been enjoying the pool for the last hour or so, then it's off to get in nine holes before dark.

> okay, I can see that as a "6" then, given the further detail. So what is your "next higher floor" after the elevation of the floor of the storag...

> I was thinking "7" too, when I first looked at the pic, but it looks like there are columns supporting the house and the blocks are basically a k...

Agree with and operate the same as Kris. I am currently involved in a court ordered survey now. Estimated the cost of the boundary work and had the ...

If at all possible, and since you traversed conventionally between the GPS pairs, I would perform a solar observation on each end just to check the GP...

It was nice to have had the chance to set in on a few of Mr. Shine's seminars. There was always something to be taken away from them.

Plus one on the service being what they advertise it to be. I've been satisfied with the work they did on my 52.

Started with a couple subdivision lot surveys, finished the day with nursing numerous yellow jacket stings.

Hey, DonHow long do you think it took before her eyes glazed over?

+1 on the CutePDF writer.After you install it, it appears in the list of printers. Set up your drawing as normal and select CutePDF writer as your pr...

Kris,If Stephen's seal doesn't work out, I'll send you mine and you can edit it if you like.

C. Went the experience route.

> What's the best device for calibrating tribrachs? What's the best device for calibrating a rod?> > Is there any tool out there that does bo...

Dale,I think it's more an augmentation to Kent's career, if I had to guess.

Well said, Paden:good: Start off with the assumption the other guy did it right. Work out from there.