Hello everyone my question involves a Spectra Precision Ranger collector with Survey Pro program I use on a daily basis at work.
I do majority topo work. I know that while I'm shooting topo I can open the map feature on the collector and see all the points I have stored. Currently all I see is point symbols and depending on the settings I can also see descriptions for those points. ?ÿWhat I really would like is to see all the line work I have shot like edges of road, edges of sidewalks ect.
?ÿ
I cannot for the life of me figure out how to have the map show my line work. I have used other collectors before and they allowed me to do so. This helps me to catch any mistakes in codes that may lead to lines heading in the wrong directions. I like being able to check all my work and make sure that I hand over a clean and correct job.
?ÿ
Can anyone explain to me how I can get it to work? We use special codes for the beginning and end of lines. (+7 to begin, -7 to end. ?ÿIE. ?ÿ BC +7 = Bottom Curb Begin.?ÿ
?ÿ
Attached is a picture of the collector and the version of Survey Pro.
I think it's in the codelist where you define it as a point or line code. Haven't worked with it on Survey Pro, but the others work that way.