Notifications
Clear all
Topic starter
I am attempting to setup and start my base (Topcon GR-5) on a known control point. We have established control points for an upcoming job that are in state plane coordinates. I entered the northing/easting/elevation for all these points. Prior to me attempting to setup my base/rover our surveyor set up his equipment and shot a base point for me to setup on. However, when I attempt to start the base and choose a known point from the point list, it says "Coordinates could not be converted".
We localize all our projects via control points and the above order of operation is how we setup on each job, but we cannot figure out how to start from a known point in Magnet. The process is extremely simple in Pocket3D.
Any help is appreciated
Posted : February 22, 2023 9:20 am