No quick connect on the GR5. Just a 2m pole, mm receiver, and the GR5 screwed directly onto that. Zero difference in setup. I have not tried the sendi...

@leegreen yes. It is the exact same .gc3 file exported from Pocket3d AFTER I had set it up in Pocket3d and calibrated the laser. However, I notice whe...

@leegreen after I select the cad line I see the option to create>points> and then select “Curve RP’s” but that doesn’t seem to be working.

@mightymoe yes you are correct. I believe that is in the “correct base” menu.

@mightymoe apologies I think mixed up the process with how we were just taught to localize. So if using the SPC, I’d setup on one of the control point...

@michigan-left we receive all of our project control, CAD files, linework, etc. in state plane coordinates. I’ve been with this company for two years ...

I would have to believe that most of the reasoning behind the process we use is for machine control. At any one point in time on our jobs we typically...

@leegreen is there any varying degree of accuracy between a localization and using state plane coordinate system? We have always just used Pocket3D, s...

I appreciate all the help everyone. as I mentioned in a previous reply, we have always performed localization from points given to us by the enginee...

@rover83 I’m still fairly new to this and I mainly assist the person who has done this for a very long time. We perform localizations on all our jobs ...