I have a separate machine that is geeked out for processing laser scanning, but I've been running this software for a long time on my older laptop.?ÿ
It is still lightning fast but it only has 8GB of Ram, and no separate GPU - which causes some video artifacts once in a while.?ÿ I know the artifacts are because this laptop doesn't muster to Carlson's recommended minimum spec, which for some reason now I cannot seem to find.
Thinking about upgrading my hardware and I would like to go a little above recommended spec so it's good for a few years, but I can't find it on their new website??ÿ Anyone from Carlson on here know where to point me?
I like a more portable laptop for EDC/CAD, the laser scanning setup travels sometimes but just gets set up in the hotel room as it isn't near as portable with the cooling dock, etc.?ÿ thanks.?ÿ I would like to use something like a Surface Pro, but I don't see any with enough RAM or graphics ability.
Their new website is not fully ready for prime time.?ÿ I found lots of dead links and fell down a few rabbit holes but here is a link to the requirements. https://www.carlsonsw.com/support-and-training/system-requirements/
?ÿ
Edit:
Their website is so unhappy that my copied link won't reliably get you there so here's a screen grab
15 minutes to answer query with correct information.
6 minutes to confirm.
Ya gotta love RPLS Today!
(I wasn't even up by then.)
@dave-lindell Isn't it fantastic??ÿ Great resource.