Last seen: April 9, 2026 12:14 pm
What was the angle between the control points??ÿ ?ÿflat angle turns between control points is going to yield larger errors.?ÿ I usually try to resecti...
Sure, select the line on the screen and export to dwg or dxf.
None would work, if I poured liquid over my screen to see which one filled, my cpu would be fried.?ÿ In the virtual world, 3 is the correct open spout...
i9-8950HK CPU 2.9GHz 32GB Ram nVidia graphics card Quadro P3200
Never would I alter my measurements so I could match someone else's work.
@skeeter1996 Good thing the the work is outdoors....
As cow said, not what a surveyor should be doing.?ÿ If they want verification of franchise utilities and municipal utilities, they can call each and v...
No standard issue SP80 does not carry all constellations. ?ÿ
I'm doing a survey of a property of someone my wife and I have known since elementary school. The owner said they got a survey online and the ci...
My first question is whose property markers did they pull those nice 5/8 bars from? 😉
This is the same government that, prior to the paperwork reduction act, the elevation certificate was a 2 page form.?ÿ Now it is 5 minimum.
@firestix I work for a Heavy Civil/Site contractor during the week building machine control models for our projects and run quantities from our drone ...
@bstrandI run a 4k 43" smart tv along side of my 17" laptop at the office.?ÿ The only drawback I have is I mounted the 43 on the wall about 4 inches t...
If you have terramodel, Export the file to a dwg.?ÿ You can specify the dtm to be exported as 3d faces, and export the points as blocks.?ÿ It will the...
XML is just a fancy generic file (like a dxf) for surfaces, points, centerlines, profiles, etc.?ÿ If you have a csv file of the points, that should be...
It is very good with the right add on for data modeling.?ÿ The roading module is great.?ÿ I have Terramodel installed, but rarely use it these days.?ÿ...
All control points for MM are established with a level or total station from project control or utilize a MM base on a control point to set out where ...
Is it a locked layer? ?ÿ
There are some videos on Carlsons Youtube page.?ÿ Look under Takeoff.?ÿ If you have a firm cad background, you should not have too much trouble workin...