Thank you @leegreen . Is there a plus side to having these line up as close as possible? Aside from maybe making it easier to perform stake out proced...
@stlsurveyor I normally run with one point as my vertical control, so I will need to shoot the remaining 3 to see the residuals. I've just passed by ...
@mightymoe Ok, that's what I was thinking but I have no experience with geoids so I had to ask. It's 5cm of error, and I was explaining that th...
As of right now, I am not using a geoid model. I have never used a geoid model, but this is the longest stretch of road I have worked on so I think I ...
@norman-oklahoma Thanks. I have two of those vertical control points shot at the moment. On the drawing the difference between the two is 0.53m. When ...
@mightymoe So, if after levelling I am still seeing a 4-5 cm discrepancy then that is when a projection and geoid would need to be applied? I can find...
@norman-oklahoma I will send it away to our dealer to get calibrated, but yeah it's something I should look into myself. I definitely re-localized, as...
I'm considering this a lesson too; to say I??ve been neglectful caring for my rover rods wouldn??t be completely off.?ÿ
Thanks to all who contributed; it ended up being the rod. I had a similar issue with a set of GR3??s, so I didn??t think it would be the tilt calibr...
@cameron-watson-pls I was wondering if the direction in which I was facing during each control shot had an impact. That’s a good idea to try wit...
Thanks for the replies! I went through the same issue in the summer, tried a couple rods (didn??t check the bubble though), and didn??t have any imp...