IMHO it is easier to go the edit raw and then adjust points command afterwards. I also like Ladd's workflow above, but I typically like just the one ....
Did you run the GPS separate from the robot work? Each time you need to save and close the file (not sure why this has been that way on my machines). ...
Don't think about it as exporting point but more processing points. What I do is save as the raw file and break it into two files (I believe this is n...
I would just import the CL polyline into the DC and then run the stake line and set interval to 25'...select the polyline and go. Been a few years sin...
Sounds like your guy is doing site review staking and not final staking. It also sounds like there is no need for grading info (a lot of subdivisions ...
Couple of different ways; For the points I would run a cut sheet using your ground run points and then select surface on the grade side.....Set the cu...
Good morning....We use Asana business level subscription...It is a web based scheduling tool with a ton of customization ability in the higher subscri...
When I saw this on the east coast it was indicative that FEMA or a private entity was doing a study that had not been finalized....I saw this 4-5 time...
We were thinking of getting T-Mobiles fleet Hub system which did a lot of what rover was discussing. Not all, but a lot...One of the demo's was to sho...
Just like Bruce stated....Deliver high end product and do what you say you are going to do. High starts from initial conversations all the way through...
Pain: Weather and promising dates....Weather is out of ones control. Committing and promising on dates will just repeatedly create heartburn. Easier t...
Holding the most restrictive will cover you legally for staking. If the builder entity wants to use the 40' setback then I would recommend a lawyer in...
I had one with 409 exceptions.....It was about a 600 acre lot about a mile from a state road down a truly abandoned county road. Came to find out the ...
That is an interesting workflow....but I have no clue. Haven't seen it do that before. Are your 2DP's closed?
Sounds like you are seeing an equation where your polyline starts and ends in the centerline routine. Not sure of your workflow, but here is my workfl...
