When I work on bridges my prference is to layout using points of the structure. Example: I would set a centerline beam/centerline bearing on one abutm...
"Offset 3D Polyline"Can you explain the routine for offsetting 3D polyline please? I have converted the profile to a 3D polyline, but haven't found th...
The translate method worked perfectly, thank you very much!
I wear long sleeve thermal shirt with Arborwear double thick hoodie. They have a giant hood that fits over hard hats. I prefer this combination over a...
0.15' H and V ?So I should clarify, the .08 error occurred at the 3 mile mark. I was running at .15 low then it went to .05 then .08 all within half a...
I came on the job after work had started. The guy that did the training for the RTK told me I should localize. I told him I want to be in state plane,...
I JUST figured it out. I right clicked on the model tab and went to page setup. The box under the pen assignment was unchecked to show plot styles.
When I try to install it does not show Carlson as an option, only shows DWG TrueView. Is there a specific way to install the object enabler?
With the RTK I am hitting the plan points around .01-.03. The pipe location is only crucial at road crossings and where it sits on existing culverts.
Oops. The error I found when I traversed was .15' The other surveyor recently ran traverse between a few of the plan control points and found 1 to b...
Yes it is the same project. I have had problems before with boundary surveyors thinking .08' backsight check was close enough to lay out anchor bolts ...
I have Carlson Survey OEM 2015, I am considering asking the boss if I can buy Star*Net. I am using a Topcon GR-5 base and rover with a Topcon Tesla wi...
I am not even 40% sure how those plan control points came to be. They are on the plans with coordinates. I can only guess they were set with RTK and n...
I am new to RTK but not new to construction surveying. The job is a complicated mess, the contract requires a licensed surveyor be involved with field...
