Reading the comments at the bottom, though, it sounds like this guy isn't really selling an ILC. He's selling a simple topo on an unbuilt lot, withou...
I've never seen ANYONE pay $900 for an ILC. They all seem to want it for $150 (the number their realtor usually gives them)... In most cases, we won...
That's actually why we've had "frequency ranges", and the area around GPS has been reserved for low-powered satellite communications, whereas other ra...
I, personally, find little value in the SDB, and would prefer to avoid it entirely. The ONLY reason I use it is that I can't create auto-linework (F2...
Now this is frightening...> Actually, we may already be there...Not quite... Those lines in GIS systems aren't necessarily correct. And then ther...
This is one reason I love this forum... So many "Survey" suckers, who love this esoteric history... :-)My first experience was with a 6" Kern with s...
On the other hand, it looks as though your labels may have been replaced at some point, at least if yours is also 1912-13 vintage. The labels in ours...
I think you may have ANOTHER piece that's missing from ours... What is that extra piece in the bottom-left? I don't think ours has that... Is it a ...
LDD3 Grading ObjectYep, there were some key commands that were not in Land Desktop itself (at least until it became "C3D Land Desktop Companion", mayb...
And I suppose my other comments could also be qualified by your statement that there were no other original monuments in the entire area. So how did ...
And if you were to be so crazy as to set ANOTHER point 0.13' from a found monument, I'd say YOU were the one who was insane... 😉
My opinion is... are your clients insane?Do they have any idea what 0.13' REALLY means?Just keep the deeds/plats as they are, and say the found monume...
> lets get our terms straight first. cad operators are technicians, not professionals.In some cases, they're both. There ARE licensed Land Survey...
Busier than we've been since 2007. Even have TWO new residential subdivision plats we're working on. Both are 150+ lots.
I, too, can recommend the Mastering book. It's no substitute for some training by a C3D expert, but if you have tight-assed penny-pinchers in your co...
I agree... We just got it, and haven't cleaned it yet. But we will... (although I think we might want to be a bit careful, and consult an expert... ...
Your's has the plumb bob! That's missing from ours.As for the details about ivory etc., unfortunately it was already sent down to our Pueblo office, ...
As aluded to in one of the other posts, the "devil is in the details"...There is a whole bunch of setup that's required to get C3D F2F to work. But o...