@lukenz About?ÿ obstructions,?ÿ yes I?ÿ had a few dump trucks and an excavator cutting my line of sight occasionally. The robot?ÿ required the 360 pri...
@lukenz I think my total time using the phone as a DC that day was about 2 hrs. I think I?ÿ started over 90% charge and ended just above 70%, so no, I...
This is a bit off topic but I?ÿ thought it is worth mentioning it here. A few days ago I?ÿ did an experiment trying to test the Bluetooth range of my ...
@350rocketmike I got over 300m range with the SD1000 connected to the RH16 radio handle on my old TPS1200, and about the same when using 2 SD1000 (one...
I tried the UD100 on my Panasonic FZ M1 with a demo version of SurvPC and I?ÿ had the same high battery drain. I?ÿ think it's?ÿ the Bluesoleil combine...
Many years ago I used the Tcra 1100 to layout points with the laser on wall forms?ÿ but I?ÿ was using SurvCE. As the forms are almost never in the exa...
A carbide tip?ÿ metal scriber will give you a very fine mark if used alongside a straight edge.
@lukenz?ÿ Yesterday I had some time to test the Bluetooth connection between my Samsung Galaxy Note 10 and the Zoom95 equipped with the ZRT long range...
@lukenz I installed the demo on my Samsung Note 10. It works ok. I didn't test the Bluetooth range yet, but the GPS search works really well. If I?ÿ d...
@lukenz Leica software won't run the Geomax Zoom 95, so I can only choose from SurvCE (really buggy in its latest iteration on my DC), Field Genius, o...
This is the new Geomax Zoom 95. It is just a week old. You can set the number of averaged readings in SurvCE in the "Equipment"/ "Configure"/ "General...
@350rocketmike?ÿ Just a suggestion. Try only 1 reading instead of 2 averaged readings. Leica TPS takes about 6 sec to do 2 averaged readings using Su...
According to this, Atr plus is integrated in all TS16/MS60 robots. We have 2 Geomax robots , one is an R500 and the other is R1000. In real life, I co...
Hammerdrill a 5/32" hole on the mark?ÿ about 1/2" deep, then put your nail in and give it a few taps with the hammer. I use this method on concrete fo...
