Besides the area conflict, that’s just a lot of word salad to get around to describing a lot in a plat.

Expecting a same day call back might have been a little much. But it seems that 3 days has now passed - still no response? That's not good. I recall...

"If i ever did that I would have them get the survey 75% of the way there and I’d finish it up." My approach would be exactly the opposite. I'd resolv...

I don't have any fundamental problem with what you are proposing. The devil would be in the details. If a protocol was worked out whereby the LS in ch...

Would the shop run a check on the autolock collimation when it was brought in?.The autolock collimation is individual to the prism being used. The sho...

"If an adjustment is ran, closure is exceptional ..." Naturally. That is what an adjustment does. It forces closure to be perfect. Fully buggered data...

It's common for attorneys who don't do this kind of work often to go to the files and find out what they did last time. And what they did last time wa...

Comment withdrawn.

"The yellow parcel was a part of the original tract from which the platted area was made." I contend that the northerly finger of the yellow parcel ha...

"Kentucky has some statutory language around road abandonment and reversion which makes it such that a formal vacation is not always necessary given c...

Triangle parcels are commonly the end parcel of a block. As such, they are where all the error got thrown. The thing to do is to develop the lines of...

I'd probably go with cold patch rather than mortar. If well packed cold patch will be as strong as the surrounding asphalt. Probably cheaper and easie...

My experience is different. I find aluminum capped monuments in asphalt very reliably. Granted, they are only allowed in low volume roads around here ...

Knee pads have been upgrading my outlook for a few years now. Highly recommended.

I've used one of these for several years and it does the job. I must say that Squirl's version is sexy, but I'm betting mine is cheaper.

I'd like it more if the dimple was centered on the face of the monument (with the state translated accordingly, of course).

It's been a while since I last used Access, but I recall that there were various settings where you specified what you where measuring up to- the slan...