Wendell, post: 357652, member: 1 wrote: SWEET! That's very cool. I didn't show you the base one, ... LOL4.3 megs of SurveyorConnect

Adam, post: 357660, member: 8900 wrote: I recall spinning a time or two after an evening on the beer legger.:beer::good: I'm sure I could get a wobb...

Thank you sir!

I wasn't aware that eagles flocked, too much pecking order establishment equipment kind of thing. Good luck with your search as it is a very nice are...

I have seen some very amazing models from SketchUp, but, most aren't that good. Basic shape modeling is fairly easy and lends itself to making 3D obj...

May not be the best way, but, you can see how I did it in this thread

I am aware of the thickness gauges that machinist's use and Googled them and came up with this . It goes to 150mm so on a thick wall it might not be ...

Great point. Western Washington isn't going to push that though!

Well, I just went looking and, .. no I have never posted finished pics other than the first page of this thread. All of the wired ones are in the fie...

Tight was by design. I place a little layer of foam on the top just in case they decide to rattle as well. What I have found is the static cell actu...

I did have to print one of the new ultimate surveying batteries and I have to say Shapeways stepped up their game. These fit so perfect, it is hard t...

My testing has shown that Trimble has locked out their software from using the Bluetooth unless it is on their very specific list. My instruments are...

LOL, I have three versions. Reader is locked into the browsers, I keep 5 around because I like the way it handles some documents and then I have vers...