pencerules, post: 344133, member: 709 wrote: I have used both and would pick the R10. The R10 is a much better receiver. Call up your local dealer fo...
Bill68, post: 344028, member: 10680 wrote: I prefer the controller separate from the antenna, but ultimately it must work fairly well under tree canop...
Nate The Surveyor, post: 343408, member: 291 wrote: The mono pod is cool. I can't seem to figure out how to change the orientation of the monopod, ie,...
Shawn Billings, post: 343485, member: 6521 wrote: It's no gimmick. Beast Mode is a base transmit setting. Higher base transmission rate improves time ...
I would agree that there is a point of diminishing returns and was not trying to suggest that correction rates of 100 Hz are needed, but rather just e...
Bill93, post: 343415, member: 87 wrote: Where is the benefit to 100 Hz? Isn't the bandwidth of the ionospheric path changes a lot less than that? I ...
Nate The Surveyor, post: 341523, member: 291 wrote: Looks like today is the day. New equipment. Or tomorrow morning.Javad LS, with Triumph 2 at base, ...
Adam, post: 341946, member: 8900 wrote: Matt8200, can I put a txt file in Google drive and import into the LS as well? Yes you can do this.
Nate The Surveyor, post: 341792, member: 291 wrote: It also has a LIVE link, to a small laptop computer, which is carried in a backpack. It is not a ...
I wanted to share a video I recorded yesterday showing a new feature that Javad has just introduced, UHF RTK corrections at a rate of 5 Hz. Increasin...
The Triumph-1M will work with Carlson software. Just select the Triumph-1 as the receiver model in Carlson.
I believe that the TRIUMPH 1M with the Victor LS will have most all the same functionality at the TRIUMPH LS with the exception of the camera views in...
Yes the rover needs to be receiving L5 corrections to make use of them in the RTK solution.
The Triumph LS does have GLONASS .2mm Dynamic Calibration. It is not enabled in the options for the Triumph 2 however.
The display shows how many degrees the unit is out of plumb. I am hoping they will update it so that when it is less than 1 it reads to the nearest t...
They keep this up....It shouldn't effect usability at all. For one this setting can be turned on and off and it doesn't effect the RTK engines abilit...
They keep this up....When the Verify setting is turned on in LS it lets you specify how many times it verifies the initialization. It does this by au...
I took a few pictures for you guys of the location of a pin in the woods that I was able to get a fix yesterday. It was directly under a large tree. ...
One way to get around this is by saving each RTN and mountpoint to separate setup files. Then all you have to do is load the corresponding setup file...
ThanksOn the map screen what do the numbers below the points mean? The point number is above the point but there are numbers like "251.72ft" below th...
