We'd be running it as network on the NY NYSNet NTRIP with SurvCE, am too interested in your results.
We've had a Focus30/Ranger3 for 4+ year, run it with SurvCE on the Ranger3. It was great the for 2 years then the radio in the Ranger3 crapped out, go...
I left it on the beach, seemed a dignified ending to its short career. Saved it the shame of knowing it was being replaced by something Swiss.
C# or F#,?ÿalways from the hub if @ all & always in decimal on front of lath, pt# on the back.?ÿI try to set 1 BM close to staking & let them ...
Sounds like NY!
We run Sokkia's (SX & DX) a Leica TS12 & a Focus30/Ranger3 combo all on SurvCE, also have a Trimble5603/Ranger2 w/SurvPro & an MS60/CS20 w...
We do it as Lee described every time the tower 'jumps' up sections. Job shuts down, crane climbs, we check plumb, #'s signed off on by DOB, PLS, Super...
99% of the?ÿdrawings I've ever opened come up with the "Missing SHX" warning, don't know if I can recall a time in which it didn't. Never had anyone a...
Seems the RPT is more like a layout laser, not really intended for a rod.
Need some of that ?? for a new gas line to my dryer.
Joe the Surveyor, post: 427732, member: 118 wrote: Hmm...let me know if you need a hand in January and February :).There are iX drivers in SurvCE 5.05
FL33404RTK, post: 426961, member: 11610 wrote: Ok guys so I've been going back and forth with my vendors on getting setup with a robotic unit. Curren...
RADAR, post: 427644, member: 413 wrote: Doesn't anybody else use a timely T-41? Carry 2-3 in my vest, one in my field book pocket and several more on...
voidintheabyss, post: 426411, member: 11972 wrote: We had a meeting this morning. All of the Party Chiefs and our immediate supervisor.Resections are ...
Got a set of column grid plans in digital and PDF from an architect. As I went through comparing the dimensions I found discrepancies, informed the co...
We often locate lowest sag point and elevation at each end but not X,Y locations. Can see it in the near future though.
ANOTHER_TEXAS_SURVEYOR, post: 422458, member: 8610 wrote: Thanks for showing this to me. I was impressed that it made point groups automatically, but...
PGM command, Create button @ bottom of dialog.