@fairleywell Does it use TIM (or similar) for Access updates? Is that an app that is onboard?

@john-putnam John is correct the problem is the Trimtalk V1 protocol, you need to change it to something generic. CMR is no problem per se but if you'...

There doesn't appear to be a lot of difference between the SX10 and the SX12 - spot size @100m is the same, reflectorless range is the same, scan rate...

If anyone would know it would be the Kara Company in Chicago, www.karaco.com.

@mike-marks I agree that GNSS isn't accurate enough for high precision building and construction layout. I don't agree at all with the "only good to a...

I use resection all the time with our Trimble SX10, mainly when performing scans. My typical MO is to set up the instrument and perform the first rese...

If that's an older unit a Trimble S6 with the MT1000 of similar vintage would run circles around it. Any Trimble robot using the MT1000 target will no...

I'm not even going to describe some of the tests I did with the R12i; if you've never seen it in action you wouldn't believe me.

I disagree about the pairing, as long as the base is tracking GLONASS and Galileo you should see the same performance at the rover. I've had the oppor...

@williwaw

@williwaw It's possible to have Access automatically update your station and backsight just like the TDS Traverse routine, it's in the Station Setup O...

I've done a couple of jobs with the Trimble X7; in both cases there were some issues with the auto registration but they were easy to clean up, I only...

I seem to remember that there is a known (to Trimble) issue with TBC and AMD processors.

And here I always thought that subsidence stopped at the Louisiana - Texas border!

In GPS terms, the almanac is the predicted health and location of the satellites in their orbital planes. It is modulated on the L1 carrier phase of e...