> I am in the middle of a cover design for the Parani stuff and I am wondering, do I need to touch the Parani once it is set up?Nope. You can progr...

I've been using the Microsoft Natural keyboards for 15 years or so, and wouldn't want to go back to a standard layout. My wrists are much happier at ...

> 1. If this is well known, makes one wonder why manufacturers aren't designing these rods with a 2 cent sleeve built-in.It's a good question, and ...

> about to retire a carbon rover rod and i'll never buy another. bipod and collector clamps and the minimal leverage exerted by either/both made v...

> For example, this adjustment appears to have passed rather well, however, the error factors should all be 1.000 (i.e. unity) in an ideal adjustme...

> And then making sure when you "run the adjustment" that it hopefully:'( passes chi test by exceeding the lowerbound lower/upper boundsNote that i...

When I first bought TBC a couple of years ago I had a nightmare of a time getting the dongle recognized. Lots of back-and-forth with Trimble tech sup...

> The RF of the radio antenna... no, it does not typically harm the GNSS side.According to Javad Ashjaee:> There is no hard rule. The effect dep...

wow!> It doesn't make much sense to me either. How can anyone patent the use of something they don't own?I don't think ownership matters, it's the...

> Tundra is their full size modelI love my 2008 Tundra!

> Measurements are being done and will be done by anyone who can master the technology and has some educational background to understand it.Heck, t...

CRTP. No UAV, just iphone and survey rod> What is CRTP?Close-range terrestrial photogrammetry.

> I'm looking for a copy/usb key for Terramodel. It is no longer sold or supported by Trimble. Does anyone know where I might be able to find a c...

[pre] KG0640'THE RECOVERED MARK WAS CUT OFF ABOUT 14 INCHES BELOW THE GROUND KG0640'SURFACE, A HOLE WAS THEN DRILLED AND A 1/4 INCH BRASS BOLT CEMENTE...

> Install the latest version of the SurvCE emulator on your PC, then open the RW5 file and export KML directly.Where can the emulator be found? I ...

Very nicely done. I remain jealous of your lathe, and am consoled only by the fact that I don't have time to play with one these days anyway.