eight counts of uttering a forged instrument That's a new one for me -- I had to look up "uttering a forged instrument." I had thought that "to utt...

I also use GE, but I find the interface pretty klunky. Having to scroll through hundreds of job numbers in the left pane can be tedious, and there's ...

Holy Cow, post: 334456, member: 50 wrote: The other was for the remaining 60 percent of the bill and in the note section said: Excessive Overcharges. ...

John Giles, post: 334451, member: 57 wrote: Sometimes newer doesn't mean better. True. But in a preponderance of cases, if a salesman tells you some...

Jon Loder, post: 334365, member: 10322 wrote: I can't understand how Topcon managed to design these two ports with the same connector right next to ea...

John Hamilton, post: 334354, member: 640 wrote: I was told a few months ago by a trainer that nobody does that (i.e. setup on known points, with anoth...

Stephen Ward, post: 334308, member: 1206 wrote: Sage has been dogging me to upgrade my 2012 with threats of no support ect. for the past couple of yea...

This is encouraging: This is the print server I use with my 450C under Win7. It's ancient, but it was cheap (around $30, as I recall, on ebay) and ...

Tyler Parsons, post: 334274, member: 139 wrote: Windows 10 hardware compatibility check says NO to the Designjet 430 and 450c. Windows 7 said basical...

Jim Frame, post: 334261, member: 10 wrote: it seems to be working again. My optimism was misplaced. After a couple of hours I checked it again, and ...

celestialpawn11, post: 334266, member: 10351 wrote: Does your HP plotter run on Windows 7, or 8 or has it just been in storage ? I'm running my 450C...

Artie Kay, post: 334252, member: 3428 wrote: Did you have any luck repairing your CX Jim? I've got the problem you had, using keyboard for everything ...

Two come to mind for me: 1. A forensic survey to determine the ownership of a 36" fir tree that fell onto a cabin, cutting it in two and killing an 8...

John Giles, post: 334195, member: 57 wrote: So somebody tell me something that would talk me into buying GPS. Do other surveyors in your area use GPS...

johnymal, post: 334185, member: 7096 wrote: Anyone? It certainly looks like some sort of RF board, and if it's Ashtech-branded it's probably GPS, but...

Holy Cow, post: 334171, member: 50 wrote: Another local service company (not survey-connected) went out of business recently because of practices dict...

Randy Rain, post: 334165, member: 35 wrote: Drop the extra coin for a solid state hard drive Have they solved the limited-write issue with SSDs? As I...

LRDay, post: 334143, member: 571 wrote: I will weld a short piece of mild steel onto a weldable deformed bar and then pre drill it. What sort of pri...