Loyal, post: 427250, member: 228 wrote: everything you want to know about PUC2. It's a great site, VERY stable and well behaved.I couldn't find a lon...

Dave Karoly, post: 427251, member: 94 wrote: We have hundreds of those PBO stations in California.And some of them are RTN stations, too.

ppm, post: 427208, member: 6808 wrote: Is there a way to group paperspace objects together like viewports and breaklinesI'm trying to imagine a scenar...

What's the function of the two unadorned poles in the foreground? Lightning protection of some sort?

vern, post: 427147, member: 3436 wrote: I would NOT reset the original under any circumstance.Not being familiar with AR practices, I'll defer to othe...

I can't help with the electronics question, but I can say that sawing through the GM300 heat sink to free it from the epoxy fixing it to the Trimble b...

James Fleming, post: 427107, member: 136 wrote: But the box don't lie.That reminds me of the words spat at a crew I was on by an irate construction fo...

Mark O, post: 427035, member: 11591 wrote: Good to know, and I'm guessing results are better b/c of the faster (10Hz) sampling rate?I'd say it has mor...

flyin solo, post: 427038, member: 8089 wrote: Well, they came in the case with the D.C. When I bought the rigs. I paid for GZR4 per the invoices. And ...

flyin solo, post: 427028, member: 8089 wrote: my experience has been that whatever epoxy they use(d)- at least on the couple/three i bought- suckedThe...

I have a GRZ4, but it's so heavy that I rarely use it. I use the GMP101 for almost everything. The Chinese knockoffs are relatively inexpensive, but...

I don't think you can make an informed decision until you have the answers to some questions:1. What's my budget? If you need brand-new top-of-the-l...

R.J. Schneider, post: 426596, member: 409 wrote: Scary was watching the old welders brasing a tap onto an active steel gas line.I watched that once an...

Hydrogen sulfide exposure?

EdWidy, post: 426494, member: 10963 wrote: But it sounds like that would only help after collecting data in the field, and would not allow me to actua...

What I do is export g-files for each RTN vector, then import the g-files into Star*Net and adjust. That allows me to control the RTN base position, w...

Mark Mayer, post: 426456, member: 424 wrote: Use all 4, get 0.12' bust. Take all data back to office and run in StarNet, no problem. So it's possible ...

voidintheabyss, post: 426411, member: 11972 wrote: we are required to traverse with set collections that have less than six minutes of error.That's an...

If the data is from this morning, OPUS doesn't yet have the CORS data to work with it. (OPUS error messages don't always point to the underlying prob...