Congrats!

Clarification for those of you not in the uncivilized parts of the world... 😉 ::pops popcorn:: means that I am enjoying this thread so much that I h...

Welcome, Todd. It was great seeing you at KAPS!

::pops popcorn::

Robert Hill, post: 327521, member: 378 wrote: How big is your point? How wide is your lathe?

Ticks are the scourge! Bites are different for everyone. If you're worried, you should get it checked. Lyme's and all the other stuff you can contract...

Brad Ott, post: 323046, member: 197 wrote: Boiler Up!Brad, PLS(first), PE Hammer down!

Thanks, JB. This should be required reading.

Thanks for all of the thoughtful replies. This has given me a lot to think about.

> the "paper pin cushion". I agree. When I see comments like this on a plat such as, "IP Found-0.25'N and 0.35' E of Corner" it makes me wonder ho...

> I say if your calculated corner is within 1-2' of those pipes and/or pin don't set something else. You'll just add to the confusion. Show the ev...

A couple more details pleaseGood Questions.> Is this a lot corner where the lots are 80 X 125 and small distances can be critical?This is a 70' x 1...

Forgot to Mention...None of those are called for. All calls are to a point.

Congrats man. I passed too!:-D 😀 😀

Ya know what else is weirdA+ sir.