wfwenzel, post: 401058, member: 7180 wrote: Bet you're glad you didn't .............. You got that right!

Eaglepoint migrated to Autodesk Civil 3d. The last email I have from them trying to get me to convert was in 2012

No need in actually looking at it first, just give me a rough estimate of cost. I won't hold you to it.

Read right at the bottom of the first paragraph on page 5

In the mid 80's when I first started working in land surveying, the old guy I worked under called anything we didn't recognize a "buggy axle". It didn...

My first thought was a cast iron pipe but it has a taper. Right below the square head is 1/2" narrower than at the bottom of the hole.James

A bearing of S45dE would be the same as an azimuth of 135d. It is 45 degrees east of due south. Your bearing is S88d15'30"E so it is 88d15'30" east of...

The bearing is S88d15'30"E which is an azimuth of 91d44'30"To answer your question, IF the bearing and the plat you show is on SPC Grid North and IF y...

Also note that on the three lines with the jacked up bearings, the distances precisely match the called distance but the other lines are all different...

Three of the bearings are to the nearest odd second and the other three are rotated about 90 degrees and to an even degree. It appears as if those thr...

Never mind, I didn't have the install file but I copied the folder on my laptop to my new desktop and got it working.James

Williwaw, post: 397022, member: 7066 wrote: Thanks Lee. You da man! I'll give that a shot. You might also try the Trimble DL app on android for stati...