Activity
 
Notifications
Clear all
gto234
@gto234
Registered
Joined: Sep 7, 2012
Topics: 20 / Replies: 77
Reply
RE: Spectra SP80 Bluetooth Pin Code

I have a similar problem with an old Spectra Epoch 35. It doesn't have bluetooth pin code and therefore it cannot pair with an android phone. It pairs...

3 years ago
Reply
RE: Has anyone pulled the trigger on the Emlid system yet?

@toivo1037 Yes, I have used their caster with Spectra Precision Epoch receiver and it works very good. Their Caster is very good and they support up...

4 years ago
Reply
RE: NTRIP caster w/ SNIP

Check emlid caster.

4 years ago
Reply
RE: SP80 base/BRx7 rover setup

Hi, I got a new gps similar to BRx7 with internal 410-470 Mhz Uhf modem that I want to use as a base station. The antenna that came with is 430-450Mh...

4 years ago
Reply
RE: Spectra Precision EPOCH 35 Receiver

The epoch 35 (don't know for epoch 50) doesn't pair with android devices that require pin because there is no pin! The only way to pair the epoch is w...

4 years ago
Reply
RE: Gnss board recomendation

Of course I look for the whole package. I just want to check which board is more futureproof and with more reliable rtk engine. ?ÿ

4 years ago
Topic
Replies: 3
Views: 4
Reply
RE: New Leica GS18 I

A lot of new Chinese receivers offer IMU tilt compensation up to 60 degrees without calibration. Has anyone experience with this new technology? Is i...

4 years ago
Reply
RE: Carlson BRX7 (Hemisphere S631) IMU troubles

Are you happy with the IMU performance and precision (if it works)? Looking for a new GNSS unit and demo'ed a IMU capable tilt correction. I was impr...

4 years ago
Reply
RE: SOKKIA GSR2700ISX GNSS receiver

@jt50 Thanks for the reply! Wow new rtk units cost under $2000? I though the cheapest chinese receiver cost about 3500$ that comes with android soft...

4 years ago
Forum
Reply
RE: SOKKIA GSR2700ISX GNSS receiver

Any feedback about the price is welcome!

4 years ago
Forum
Topic
Forum
Replies: 4
Views: 4
Reply
RE: PDL UHF modem question

The test was successful finally! I used a kolida receiver as base broadcasting corrections over uhf using Trimtalk protocol and RTCM3 format. My recei...

4 years ago
Reply
RE: PDL UHF modem question

@lurker Ok I did configured the frequencies by using PDLconfig tool from Trimble. Now I have to check if it receives the corrections from another uhf...

4 years ago
Reply
RE: L1/L2 processing

You can use RTKLIB open source tool for processing. Check/p> There is wealth of information on this site.

4 years ago
Page 1 / 7