AI Assistant
Notifications
Clear all
david-livingstone
david-livingstone
@david-livingstone
Member
Joined: July 22, 2010 12:44 pm
Last seen: June 2, 2026 12:10 pm
Topics: 48 / Replies: 1088
Reply
RE: Keeping track of movement.

RADU, I don't know? I could set a spike near each rod and keep track of both.JUD, these are duplexs and I'm not sure if they own very much ground out...

16 years ago
Reply
RE: Keeping track of movement.

The base is permanent mounted on top of a 7 story building at the university.I just plan on using the RTK to check and make sure the street isn't movi...

16 years ago
Topic
Replies: 8
Views: 823
Reply
RE: Youv'e probably seen it.

I'm pretty sure its not a Rockwell, but you never know.

16 years ago
Topic
Replies: 11
Views: 792
Reply
RE: Unknown use of a survey

I agree, just because the surveyor did not contract with a 3rd party, does not let them off the hook. Did they have a contract with the original owne...

16 years ago
Reply
RE: Don't Anger! me!!!

Is there any chance that said "Danager" at one time?

16 years ago
Reply
RE: Things I've heard while surveying

"Is this where the new 4 lane is going". Followed by a "yuck, yuck, yuck" like it's the funniest thing in the world.

16 years ago
Reply
RE: GPS for suburbia lots..

I will also set pairs of points to shoot a point in the trees, but I'm setting a pair of points with RTK that are a few hundred feet apart, and then t...

16 years ago
Reply
RE: GPS for suburbia lots..

I would never use GPS for surveying small tracts, like lot surveys. Like someone else said, its not accurate enough for short distances. Why use GPS...

16 years ago
Reply
RE: Court

Two things that suprised me when I went to court. If you are the expert for them, you can sit in on all the trial if you want. I thought you had to ...

16 years ago
Reply
16 years ago
Reply
RE: Ideas on making AutoCAD line style.

I tried it by putting a text in using the lower case "o", and then using text mask. The problem is the text mask is square, so it looks funny. I don...

16 years ago
Topic
16 years ago
Replies: 13
Views: 870
Reply
RE: Did I pincushion?

CarlCarl, if there is one thing I've learned in surveying, don't say never or always. You have to have an open mind. I don't agree with what you did, ...

16 years ago
Reply
RE: Carl (RE: Pin Cushion Thread)

Geez, I see several variances between platted and measured. After reading some peoples comments below, are you sure you shouldn't have reset all thos...

16 years ago
Reply
RE: Did I pincushion?

KentI'm just guessing here, but I bet a skyscraper isn't located on this lot within 0.14' of the boundary line. I can't imagine the state or county o...

16 years ago
Reply
RE: Did I pincushion?

Kent, we get hung up on numbers. I think we can all agree that if the pipe was off 10' we wouldn't use it. It works the other way also. I think we ...

16 years ago
Page 56 / 57