Yup! See you there.
Perhaps .....the most intelligent comment of the day! Yes, worry about your own state and don't pretend you know what goes on in mine. Most of the t...
I guess my first question is it accurate enough to matter? It is my impression that most "fish finders" have a lot of slop.Then how about long term e...
I've never had a cup of coffee in my life!And BTW - this is not unique. There are several other states that will not accept another's Minimum Standar...
Why should it? Illinois standards have nothing to do with TN?
Because the LAW says that original gov't monuments are good. The law does not say that about corners I set. That's why.If my corners were always rig...
Brian - sometimes a surveyor or his crew just plain old screw up. Bad back site, bad fore site, set on the wrong control point, just plain old sloppy...
To me - this is a no brainer as presented. Mark the platted line and set proper corner.I would think twice however if Surveyor B's pin was in the ori...
Most RentAll stores - especially ones that serve contractors - have them for rent. But I bet you can find a BeerLegger that will loan you one.
One of my major pet peeves ....is when some store clerk thinks that a ringing phone is more important than the person standing in front of them ready ...
If I remember correctly there is a setting option to continuously roll out the oldest files to make room for the new files. Check that.
Oh, I just can't resist ...I shouldn't say it, but I'm going to.The way most of them were sticking up in the air in plain sight I think even the Power...
Started off double majoring in Math & Physics.Finished with degrees in Economics & Business Administration.PS - The degree in Econ was because...
I never tore up clothing either, but ....I have destroyed a few handkerchiefs. 🙂
I have done it two different ways.1.) Used PVC pipe with a rebar & cap in the middle. Liked them for ease of making and carrying around, but not...
Actually I'm able to do everything indoors under controlled conditions. I may not have all my screws quite tight, but I ain't dragging it outside jus...