Trimble L2C, John Send Me A RINEX FileThat's what we were seeing when we looked at the data reports. With L2C off we'd get 4 nice neat columns. With...
Yes - discovered that recently as well - R8's Model 1. We had the base set with L2C on and the rover set with L2C off. We'd run sets for OPUS and th...
Looks to me like you'd better go back to the drawing board and start over. Kind of sloppy don't you think?! 🙂 😉
Like you, I normally don't use 3 wires for leveling, but I know there's a lot more to it than just blunder checking which is all I have used it for wh...
I've used this example before and I'm sure it will be used again to try to make a point. Let's say you've got a string of lots that were created by a...
He's reading Zenith angles, not vertical angles. And he's reading both faces.With Zenith angles, 0° is straight up, 90° is horizontal, 180° is straig...
GLO Iron Monuments - Here are scans1930 Manual:1947 Manual:
No diagram, but check section 242 of the 1930 & 1947 manuals. But then you've probably already seen these.
SearchUpper right hand corner - window with magnifying glass.
I have seen things like this originate in wills for various reasons.
Machete and plumb bob. Prism pole works pretty well too.
Here's a discussion from a couple days ago:
I went down my basement and drilled a small dimple in the concrete floor. Then used a plumb bob to measure a point directly over the dimple in a door...
As always - nice pics! And once again, I'm envious of your "work".
A common practice with transitKent has alluded to this, but a common practice with a transit with a compass was to not only use the transit to measure...
For most of us "metes & bounders", lost or obliterated means "it ain't there".