AI Assistant
Activity
 
Notifications
Clear all
bill93
bill93
@bill93
Member P&R, Founder
Joined: July 1, 2010 9:00 pm
Last seen: September 19, 2026 8:16 am
Topics: 291 / Replies: 9708
Reply
RE: Handheld GPS recommendations?

The units work in ITRF or WGS84, of course. My OLD Garmin uses a null transform to/from NAD83, based on the original documents from when no better dat...

6 years ago
Reply
RE: A Good Man With a Sawzall (Boundary Dispute)

The comment misses the rule of monuments over measurements. That limits the effects of accumulated errors. Otherwise it seems a fairly accurate commen...

6 years ago
Reply
RE: Water Surface Elevation

The OP said a "still pond" but since that may not be the case at the time you want to visit, the stilling pool is a good idea.?ÿ It's best if the buck...

6 years ago
Reply
RE: Water Surface Elevation

Depending on finding a convenient location, just putting the rod at the water line on the shore is simpler and probably just as accurate.

6 years ago
Reply
RE: Why?---Think about it

For every surveyor who has learned the history of the area they work in and do the research into deed records, corner records, adjacent plats, etc., h...

6 years ago
Reply
RE: Rassenfrassen reviewers.................

Information on a document should be as correct as possible.?ÿ It does seem she is going beyond what the job description in many places would entail. ...

6 years ago
Reply
RE: Backhoe use to recover survey stones

You beat HC and me to that one.

6 years ago
Reply
RE: Resection error

The idea comes from angle-only resections.?ÿ When you measure both angle and distance the old limitations are relaxed.?ÿ You still need control points...

6 years ago
Reply
RE: Long antenna cable...how long is too long?

Actually, your receiver gets 1/4 of the signal power; the cable loses 3/4. But that is the signal after the preamp in the antenna assembly boosts it....

6 years ago
Reply
RE: Resection error

0.05 at random, rotated in the same direction, different radius from resection point, or what? Can you shoot from one control point to another (even ...

6 years ago
Reply
RE: THINK - checking CAD linework

Look closely at the line work.?ÿ #1, #2, and #4 will not receive any because their tubes are closed.

6 years ago
Page 178 / 500