@bill-c Again, my thanks for your post. I had overlooked the transformation from NAD83(CSRS) to NAD83(2011). Although the horizontal difference didn...

@bill-c Thank you for that, Bill. I will review.

@not-my-real-name Yes, I'm in Mass. I've occasionally used MassCORS for RTK work (without base) but generally I work with my own base and rover. I'v...

When I was first getting into GNSS, I purchased some old Trimble equipment, and a license of TBC. I did some in house post-processing at the time. B...

Subscribing to this topic.

Looking at AUSPOS now. I like the "scan" feature which reads the RINEX file for the height of the receiver and the antenna type. But, using this fea...

Terry, Thanks for the response. I don't think there were any issues with multipath due to flat surfaces (buildings) or with radio interference due ...

Jon, I used my phone's front facing camera, which unlike the rear facing camera does not have an infrared filter, to make a short video of the laser p...

Jon, thanks for the suggestions. This condition has occurred on several days in the field. Unless you mean by “reboot” something more than turning off...

I found the following troubleshooting steps related to failure of the turning operation. I will check these. Is there a simple test that can be used t...

I found the manual for the Sokkia RC-PR5. It can be viewed at: Starting on page 11 (section 4), the manual indicates the following: The Remote Contro...

@murphy Like the idea of the tapcon screws.?ÿ Thanks for that.?ÿ What's the ideal timing for their use - 24 hours after pour??ÿ And, is the idea that ...

@flga-2-2?ÿ It will be a fairly big, fairly elaborate home. ?ÿFull basement, enclosed garage, walkouts, etc. All the walls are square so nothing out ...

I appreciate all the suggestions.?ÿ Interesting how varied the methods and materials are.?ÿ I've been using 8" mag hubs, but have found them to be som...

It is a good question.?ÿ I suppose a related question that might be asked is: "Does it result in any benefit by its presence or absence on the face of...

@paul-in-pa Paul, I tried WinTeqc but I couldn't get it to work.?ÿ It wouldn't write the output file.?ÿ I've contacted the maker to see if he can pr...