As James Johnston would say....:good:

Yes. I still use solar observations.

> My question: Can not subscribing to these second party services be considered a lack of proper research?Given that you *know* about these service...

Happy Thanksgiving from the Piney Woods of East Texas.I'll take up the slack for you until Wednesday evening. 🙂

Casio fx-260.

> > MIG fills holes way faster though and is superior in many ways when speed or large gaps are present. They just don't look as good.In the ...

> "As I tell my wife, you ladies duke it out and I will take the winner and console the looser"> Wouldn't the *looser* of the two be the winner ...

Leon,Now seems to be the perfect time for a preplanning conference with your clients. This would be the perfect opportunity to prepare them for what ...

> and here I thought I was using an Allen wrench.Don,You may very well be. 🙂

> A couple quick questions:> > 1: What tool is best for adjusting the calibration screws of a tribrach bubble level? (Also, what are those sc...

> Update. It was a bad cable causing my issues. The collector is working fine with the gpt 3003 now. Heeha! Less hand notes for me.> > Now to...

I'm convinced that my wife's lineage comes through Brunhilda. :/

> VERY nice!!!> > Now build a tapering jig so you make some shaped table legs.Eric,I've found the jointer be my tool of choice for tapered ta...

Thanks, Jimmy.

Jimmy,Are the side toolboxes custom made or did you buy them somewhere and install them yourself?

> I am working on an ALTA update, and I have been furnished a zoning report. The zoning report indicates that the zoning for this property has a va...

Will the co-op be the one hiring you? If so, that would be the "client" I would be informing of the potential problems with the upcoming " falling of...

> I came here to ask one question and hopefully someone on this forum will have the answer. I can not give over any information concerning this in ...

> I've always preferred symbols that sort of look like the object they represent.> > > Bruce,What part of the wagon wheel do you normally ...