See above.. Got KO'd by the high overcast 🙁
I was wonderin what to do with my old range poles... I can help out but I am only in the Kansas City area... you say 24 feet of range pole plumbed and...
Good Day, The Big Ten Went 3 For 4Not claiming Minnesota? 😉
Bye-Bye Bama??Maybe THE Ohio State did deserve to be in the playoffs. Not over yet but the fat lady is warming up. Nice showing by the Big Twelve tod...
Nice job... should work well, especially w the bipod. I hadn't thought of that. To me, it's much better than the lightweight tripod most of these come...
rfc, Seeking Enough Knowledge To Be Dangerous:good:
> I have one of the W-K Forester's Compasses seen bottom center. I used the hole to run a wood screw into the staff to affix the bottom part of the...
Looked at some of the ball joint mounts I have and found all but a couple have that hole. The hole in the Warren Knight cruiser adaptor is threaded no...
Well not to be argumentative.... but I thought Jim was looking for advice about his forester style compass. I only offered up my experience with same....
Pardon my misspelling.... I meant to say my name is not Sipedunno where Sikes came from??
> Jiminy Christmas!> I don't think anyone would expect an inexperienced uncoordinated compass mishandler out there anyway. I don't know about th...
To me, the only way for one guy to get good results with a forester type compass is to use a tripod. Just too many things to juggle when using a staff...
Gas for my car was 185.9 this morning at the Valero but diesel for the truck is still up at 285.9, which is about 75 cents lower than it was but why i...
Beautiful and no yellow crayon to highlight the scribing, no hi-vis paint or flagging, nobody has felt it necessary to drive a 2 bit rebar along side ...
Forgetting that the man had made an inquiry regarding a potential job, would you be sending along your condolences? I think not... I think Wayne has i...
Bill has given you some good advice. I don't know if he will but I am sure that Kent could add a lot to this thread as well.Good Luck
Remember when selling on Ebay the first 12% or so goes to them. Then there's the shipping angle to be concerned with. You want to ship a high value it...
Never really drug a gunter chain. Did mess around with a K&E 33 footer, I have, but supported it like mentioned earlier. BTW, I have a nice K&...
Just checked and it is not the printer you mention, it's number is MFCJ4420DW.. I think it's the lowest price on a printer that will do an 11x17 I've ...