Using LDD3 in the "list points" screen, I have somehow managed to get certain points listed and cannot view the others. I figure it has something to do with point groups but not sure. The part with "401-405,410-411,420...." is stuck there and every time I try to get rid of it, it comes back. I tried adding to the list and it reverts to the same parameters.
I have never used point groups so there's still a lot that I don't understand about groups.
Any help would be appreciated.
James
I haven't used Land Desktop in over 13 years, and even then I think it was a later version than LDD3, but my first thought is that you should look at the Include tab. The radio button with List All Points checked is confusing, but normally, even with Civil 3D, you establish your parameters though the Include tab. Perhaps give us a screen shot of that tab if it's still giving you problems.
I think I have it figured out the points that are not showing up were not from LDD3. It's an old drawing but I didn't think it was that old.