Have you saved the workspace after you configure your layout??ÿ ?ÿCommand line WORKSPACE?ÿ ?ÿor click the gear in the lower right corner of the screen...

Under Cogo, use traverse.

As BlitzkiegBob says,?ÿ get the C3D drawing exported to standard acad entities and surfaces exported as xml.?ÿ Carlson has a converter that works most...

The instrument will sight the prism off center when tracking, it adjusts the horiz and vert reading accordingly.?ÿ?ÿ

The article I read stated that the jamming affected the civilian side of the GPS network, it had little to no effect on the military side of the signa...

Look for a file named WMDCRegistryUpdate.exe on Trimble's support page.

join the lines back into polylines.?ÿ Elevate the polylines to the correct elevation.?ÿ Create the surface from the elevated polylines, but without br...

Sediment traps

As Lee said, you will not see any difference between wifi to cell modems.?ÿ The data stream for GPS is extremely small.

This is a known issue I have always had. When you setup on a known point and the BS derives an error, when you store your setup, it will adjust the oc...

No degree for me, I guess a perpetual freshman =)?ÿ Have a couple certificates on the wall from a community college and university for a few classes I...

I breezed through the exam in about 80 minutes.?ÿ The questions will be straight forward.?ÿ Good luck to those taking it.

Easy answer to you question is yes, you will see questions from most if not every one of those references, including the regulations (White book as we...

I would check for video driver updates from the card manufacturer ?ÿ

I have a PLLC in Virginia.?ÿ Sole member.?ÿ If I want employees, I will have to restructure.

I go to the clients, they don't come to me.?ÿ My office is in my house.

If you are using a 2m pole, then use 2m height.?ÿ ARP is to the bottom of the unit.

I purchased a schonstedt on ebay a couple months ago for $325 + shipping. Worth every penny.

Wouldn't matter about the addition, it's part of the building. I'd use the relevant diagram number for the main structure and note the additional elev...

I've never selected objects that way, I usually pre-select all of the objects I want to modify and the type 'select' 'p' to make sure that I have them...