AI Assistant
Notifications
Clear all
tyler-parsons
tyler-parsons
@tyler-parsons
Member
Joined: July 2, 2010 7:55 am
Topics: 59 / Replies: 495
Reply
RE: Dead Rebar

I have one of the indicating Schoenstedts GA-72. Most in-place monuments show indication to the right side. When I buy new rebar, I test each with the...

9 years ago
Topic
Forum
Replies: 0
Views: 732
Reply
RE: Kelsh Plotter - free

Shelby H. Griggs PLS, post: 411570, member: 335 wrote: Those things were antiques 40 years ago, LOL. We had a couple in our photogrammetry lab in coll...

9 years ago
Forum
Reply
RE: Professional Land Surveyors of Oregon Annual Conference

Nice to see everyone again. Hopefully I didn't miss a scheduled Beerlegger?Thanks to the Conference committee for another great meeting.

9 years ago
Reply
RE: Flood Vents

I queried my State Flood Hazard Manager - a very nice lady who gives FEMA seminars at our annual conferences - about the installed vents. She indicate...

9 years ago
Reply
RE: Flood Vents

Thanks all for the information. I obtained the manufacturer of the vent from the installer. It was Air Vent. Fortunately, they obtained theirs from Lo...

9 years ago
Topic
9 years ago
Replies: 10
Views: 922
Reply
RE: GNSS Solutions multiple occupations

Mark Silver, post: 403507, member: 1087 wrote: I prefer to initially give them separate point ID's, as you are doing. Then after I verify that they re...

9 years ago
Topic
Replies: 9
Views: 639
Reply
RE: Are You Getting Pelted With POB Notifications?

This is adding insult to injury. About 1-2 months ago, I tried to log in to rpls.com. Couldn't. Tried to change my password through Forgot Password. G...

10 years ago
Reply
RE: Flood Insurance Study vs FIRM

Thanks for the Help Guide. The situation is complicated by the fact that the house supposedly sits in an X zone island (out of flood plain), but with ...

10 years ago
Topic
Replies: 5
Views: 362
Reply
RE: How to remove old prism pole point?

This usually works for me: Heat the point and/or use penetrating oil, then put the point in a vice and a use rubber strap wrench on the pole. The stra...

10 years ago
Page 3 / 28