Yes University of East London have a couple of degree courses.I wonder if there used to be more degree courses. I was surprised how few there are. I c...
Yes civil engineering courses have surveying modules. So nearly all "Graduates with the skills to use surveying equipment" from the UK are actually ci...
Interestingly the University that held the event does not actually have a surveying course. In fact there only a few surveying degree courses in the U...
Forgetting point 3 for the moment - the azimuth error between points 2 and 4 will be transferred to the derived co-ordinate of point 5. (i have assume...
What about the backup battery?Don't know where it is but I think there is one.
Thanks Chuck. Are you speaking from experience? I'm thinking that all the imitations probably come from the same place.
Yeah I was wondering about putting it on the belt sander. 0.25mm each side?
maybe it's an aussie thing
OK, but the reason I said it was that mine does the same things that you have described when the battery has totally run down (or it thinks it has).Tr...
could be the battery is not accepting a charge.can you test with one you know has charge?
You've opened it in AutoCAD already?Using ID command with Autosnap will tell you the co-ordinate of the point.eg use "nea" autosnap to snap to a conto...
You kind of need to be at least slightly "bilingual" here, but I can't imagine doing my surveying in anything other than metres and millimetres. We st...
Ah I found the calibration setting for Autofocus on the Instrument face 2 display.I imagine this has never been done. Seem to need a prism at 500m+ di...
I have Autofocus ticked in Instrument Settings (Long Press on the instrument icon below the battery levels, Trimble Access).I have never actually seen...
I don't have a calculatorOnly turn angles in 50 gon increments.
Thanks for the tip Jim. I've located a bit of 1.25" OD stainless tube on ebay - normally used for mending car exhausts I think.I may combine it with ...
Ah, I see. Is that type of rod prone to letting the inner rod slip down for some reason?
Never sure what the pin is for on those type of carbon fibre poles?
Houston test equipments aka "wesellem" sometimes have them.