Yes it is tracking satellites for a minute and then giving up.We're not working till Monday so I will re-check over the weekend and downgrade then if ...

Same here with SPS855 firmware 5.03The table shows it tracking one GLONASS satellite at a time strangely.

I would love a ZNL but can't justify the cost as don't do hirise anymore. I have seen a ZBL cheap near me with a broken plate bubble. Do you think it ...

He he I do think that sometimes myself. There is a bit of an obsession with scanning with the engineers and architects here. Then they get the cloud a...

StLSurveyor, post: 350778, member: 7070 wrote: In theory, we can scan a shopping center at night (i.e. Wal-Mart), come back in the AM to pick up the u...

Kris Morgan, post: 350401, member: 29 wrote: I think the lag in the time from the reference station has something to do with it. 20 miles and under s...

Kris Morgan, post: 350396, member: 29 wrote: We have both. R10 if you have great cell service AND the reference station isn't far. R8 if you don't h...

Conrad, post: 350387, member: 6642 wrote: hello squowse, start from the left. each piece goes on top of the piece immediately to it's left. piece 4 wi...

It's OK I got it.Those 4 little holes are for turning the top plate from above (with circlip pliers). There is a very short thread that holds the top ...

George Matica, post: 350371, member: 6663 wrote: I've ordered checks for the "big check book" 😉 What do you like about the R8-4 compared to the R10?...

Lee D, post: 349967, member: 7971 wrote: You can easily inverse a point to a line in the calculator - I'm not sure why they bury it so deep. Go to the...

Bill68, post: 350121, member: 10680 wrote: Actually I'm just learning Access as well because we just purchased an R10. I'm not finding the software t...

resection or free-station?

There are at least 3 DR types on the S6 though. (different options and editions) Some are better than others. I think on the whole Leica have always...

In Access there is now a choice of methods. The new one requires angle observations to both edges of the circular object. It then bisects them and tak...

I'm going to do a test tomorrow. I'll use 1 R10 as a base and 1 as a rover. They are both GALILEO and BEIDOU enabled so I will see if they will use th...

:beer: Plenty of good trimble knowledge here on this board (Just as well)

If they have had the appropriate unlock code purchased and applied.