Last seen: March 14, 2025 3:27 pm
James Fleming, post: 456250, member: 136 wrote: "The greatest trick the devil ever pulled was convincing the world he didn??t exist. And like that ...
Thank you, Frank. I don't get territorial about much, but reputation and a phone number are probably the most valuable assets a surveyor has. I apprec...
[USER=472]@Frank Willis[/USER] I've explained my relationship with Javad already and won't plow that ground again. It's there if you care to read it. ...
No I don't use localize to refine the base position. I only use localization to match a local system (with unknown relationship to the Earth) to a geo...
I've been pretty busy since getting home from Arkansas. I wasn't planning to work up the report, but I was asked to do so by "Team Trimble". We had a ...
Lee D, post: 455517, member: 7971 wrote: The few times I've needed to do one of these I looked at all of the parameters of the transformation, but pri...
leegreen, post: 455797, member: 2332 wrote: Same process with Topcon Magnet Tools. Not sure why this is so eye oping to some.Maybe old apps like TDs P...
eddycreek, post: 455792, member: 501 wrote: I also missed the logic in that. The first thing the Trimble Sitech guys will tell you is to make sure you...
MightyMoe, post: 455515, member: 700 wrote: There were a number of things in the video that I found unsettling. He glossed over changing the numbers f...
Frank Willis, post: 455472, member: 472 wrote: Hey Shawn, any preliminary results?Soon. Just need more time to do it justice.
MightyMoe, post: 455475, member: 700 wrote: Yes, you can drill down in the data if you want, what I saw in the video basically confirmed my opinion th...
MightyMoe, post: 455450, member: 700 wrote: Using Trimble you can walk through and back out of using points, look at the residuals.Basically it's the ...
MightyMoe, post: 455438, member: 700 wrote: Well, I watched it, it's the same thing Trimble does for a calibration.That's why I shared it here. I'm no...
It was a great time. Camping out and swapping lies around a fire. I really enjoyed meeting [USER=7070]@StLSurveyor[/USER] and Mike Goforth. Always fun...
To OP, yes.
Jim in AZ, post: 453651, member: 249 wrote: Agreed - the ability to "adjust" measurements is a task well-suited to the "expert measurer" rather than t...