geopro_consultants, post: 373732, member: 9959 wrote: I've always been a full Trimble user and I like the way both GPS and total station can be used w...
dmyhill, post: 373692, member: 1137 wrote: Is this a difficult DIY? What would the dealer do differently? No- it's not a difficult DIY- usually a we...
If you are still having issues with a DIY contact cleaning I might suggest visiting your dealer and getting it done there. I'm sure it'll take just a...
Moe Shetty, post: 373677, member: 138 wrote: yes, i'm scouring my memory of what model it was. i do remember it was a leica, and that NGS had bought t...
Moe Shetty, post: 316414, member: 138 wrote: I was recently involved in the measurement/recording of a new EDM calibrated baseline. It was fascinating...
THANIN, post: 371588, member: 11688 wrote: I am using both of Sokkia GSR2700 Isx, and now I don' t know why they are stop working even turn off the re...
leegreen, post: 371022, member: 2332 wrote: Steven, You or your boss went the cheap route. The DS is the lowest end Topcon Robot with out any type of ...
MS SURV, post: 370917, member: 10318 wrote: I am using a PS-103a (auto-tracking vs. "ac" auto-pointing) paired with a TESLA running MAGNET Field. Forg...
The Builder Series 360 Prism (1004684-01) is built to our specifications to offer a lower cost but high quality 360 prism alternative to our ATP1 hi...
The ATP1 Prism can be pointed in a higher accuracy way. On page 47 of the RC manual you will find a graphic demonstrating the following-Align the hex...
clearcut, post: 370036, member: 297 wrote: I have observed an issue with the Topcon QS series robot using a FC 2500 DC w/Topsurv software. In that it...
ekillo, post: 370089, member: 773 wrote: I have found that the plastic coffee stirrers are a good substitute for stylus in a pinch. Golf tees work we...
mvanhank222, post: 369938, member: 8673 wrote: Did it happen at the end of a setup. That's what it looks like when our Sokkia goes out of level past c...
MS SURV, post: 369873, member: 10318 wrote: pmoran- I am investigating Topcon University, quick guides, etc. but we do not currently pay for this supp...
Paul, post: 369866, member: 624 wrote: Running TDS Survey Pro here. I believe it was Survey Pro there as well. Both Topcon robots. Could be somethi...
Paul-What DC package are/were you running here and there?
I'll leave you with one more comment- whatever you buy- buy it locally from a dealer that can service and support your purchase. Just remember the gu...
MS SURV, post: 369814, member: 10318 wrote: I am a novice survey crew member that has been asked to learn MAGNET Field on our TESLA for use with ES-10...
This is not a totally objective response since I work at Topcon/Sokkia. Try a Hybrid combo from us if you have a reasonable RTK network where you typ...
In the Air Force you'd send a guy down to Supply to get 100 feet of flight line.
