This would have been much easier if someone would make a single device that has all of this built in...modem and Ntrip Caster. Of course the R10 has i...

I finally got all the connections working. My R10 started working again, I think AT&T fixed whatever it was they did. Trimble says it is definitel...

My wife and I went to Canada about 25 years ago, with my young daughter, this was before you needed a passport but also before she was a citizen. The ...

Dave: thanks for the links. If you don't know the links, I don't know of any other way to get to the beta sites, correct me if there is a page where y...

I am only licensed in PA. But, I can tell you that a friend who has 4 (I think) licenses said Michigan was the hardest.

I may be totally wrong, but I think in orbit repair can only happen at lower altitude, at least from the ISS. Seems to me it would be prohibitively ex...

You get what you pay for. Probably a reasonable LiDAR setup would be in the $35K-$70K range. Of course, it needs to have an IMU. Being that drone flig...

That's ok, you may need a license to receive Galileo anyway...Pretty ridiculous...since when do you need a license to RECEIVE a signal? Someone told m...

I have a pole that is made up of 6 ~1' sections (makes a 1.8 m rod), collapses down and fits in a small pouch. The only problem is that the bipod or t...

Sorry to hear that, Shelby. He looked like a very interesting man

we had issues last week on the Trimble VRS Now network, could only get GPS with an R8. I was using an R10 on a different Trimble VRS (run by a dealer,...

The latest: the cell modem no longer works since AT&T cut off 2G. That is a given. It supposedly is a 3G modem, but that is still yet to be determ...

Actually, you can select either 0.5 w or 2.0 w on the R10 UI, that is a nice feature to be able to change it like that as needed. I use the low power ...

As I posted last week, apparently older R10's have a 2G modem, even though they were marketed as 3G (at least on the 12/14 data sheet that I have). So...

We transferred positions inside a dam from the surface to an air gallery located inside the dam through small shafts at each end. I used a T2 (newer m...

I did get two pages called "miller references FB 3-007" (pdf). I did not realize what they were, very basic sketch on each page, but now that you ment...