> "instrument failed to turn" You should NOT be getting that message. That's the instrument failing to respond to a command or returning with a '...

> "instrument failed to turn" You should NOT be getting that message. That's the instrument failing to respond to a command or returning with a '...

Yeah Mate, just whack the crocodile clips off and replace with spade terminals - easy as. You might want to use fully insulated or self sealing termi...

I've seen those anderson connectors but not on a charger locally (down here in NZ), guess not hard for an electrician to cut the ends off and reconnec...

When I changed the elevation on the static point it deleted it I doubt it was deleted - Access very rarely does that - much more likely for it to h...

Grab a plastic toolbox from mitre10 and stick it in that.

How much accuracy do you need? A good gnss used properly will give results at around +/- 2 cm A good total station around +/- 2mm I would not use g...

You could try keying a completely new point combining your local coordinates and the opus elevation and use that for your calibration.

That's it exactly, Mike. The ebubble is actually pretty rugged and reliable. But they are subject to shock.?ÿ In my experience, the times you find t...

That's one big hint that your gps has been dropped. Some crews are more careful than others. Also if you can't get the pole an ebubble to reliably ma...

That suggests you actually still have the eBubble enabled, just not showing.

And not changed also The weather is still (sort of) the same The hills are just as steep Its just the measuring that is getting easier

For me the big bonus is in stakeout. I am just SO much quicker with the inertia unit on. And the safety aspect is a genuine bonus for every one. But...

@OleManRiver Trimble Sync Manager is a front end for Trimble Connect. It builds Access jobs in Connect and uses those facilities to distribute the job...

When you say 'recording' - can you explain a little more please What data are you looking at? and how? If it is Access job, which version (it is on ...

@350RocketMike Makes no difference where the dxf is. I would put it in the project folder.?ÿ That way you have only one copy - each job works with ...

And me? I am not fan of the red/green tracklight. I'll take the video feed option instead. But this one really does seem to be a personal thing - u...