Last week I found myself perched on the top rail of a 6-foot wood fence as I navigated to a corner monument. The thought of losing my balance and hav...

Are you the one who chipped that giant gouge in the concrete just to keep the leg from slipping?

flyin solo, post: 433465, member: 8089 wrote: if you're gonna borrow money, not sure how you could beat 0%.As Lee indicated above, you beat 0% by gett...

The book below is pretty typical for me: it spent about a year in my inside vest pocket. The cover fabric is smudged here and there, but still intac...

I've never done either one, but my assumption is that the equipment seller is going to mark up the cost of lending you the money to buy his equipment....

Related: punching in a phone number on my desktop keyboard and expecting it to show up on my phone.

My sharp points were delivered yesterday. They're definitely an improvement over the blunt ones (on the left): I still want to tune up the point so...

Interesting spring-loaded approach to keeping the legs attached to the head.

warren ward PLS CO OK, post: 433099, member: 12536 wrote: It does not affect title.Do title companies typically review these plats? Is there anything...

Dave Karoly, post: 433013, member: 94 wrote: WE ARE SURVEYORS, FOR CRYING OUT LOUD, WE MEASURE THINGS!I agree that variable-height setups can be used ...

It's a very clever design. I imagine that it's not quite as good as having each of the dedicated tools, but if you don't have room for all of those i...

Hey, I remembered!:M 19-1-15 249.1424 94.043 89.4818 4.832/5.000 'FND 5/8" RB LS 6829

Kris Morgan, post: 432934, member: 29 wrote: I love this descriptor. 🙂 M 19-1-15 249.1424 94.043 89.4818 4.832/5.000 '...

I think the reason the PH at 31 warped the adjustment so much is that I entered a rough geoid height rather than a rough ellipsoid height.Dave Karoly,...

Richard Imrie, post: 432815, member: 11256 wrote: I mentioned in another thread that we wore down a good 5mm of tip in a 60,000 shot urban topo.That's...

Kent McMillan, post: 432811, member: 3 wrote: It applies the default standard error set in the Project Options tab,Not according to the manual, at lea...

The adjustment is run in pure SPC using the CRTN value for UCD1 (the RTN base in this case). I do have a ground conversion specified that also transl...

Here are the results of processing with GPS only. These were mostly RTK, with a handful of very short (5-minute-ish) static sessions, and I used a sc...

Kent McMillan, post: 432774, member: 3 wrote: Why isn't that a DV line instead of an M line? Change it to that and tell us if the problem disappears.T...