AI Assistant
Activity
 
Notifications
Clear all
jaro
jaro
@jaro
Member
Joined: July 5, 2010 10:11 am
Last seen: May 21, 2026 7:59 pm
Topics: 145 / Replies: 1577
Reply
RE: Mapping Underwater Pipes Question

If the pipe is visible underwater (not silted over) you might could try an underwater drone dragging a styrofoam float with reflective stickers on it....

9 years ago
Reply
RE: Can't wait to retire

Lookinatchya, post: 455485, member: 7988 wrote: I still enjoy surveying but I thing I am starting to get grumpy old man syndrome. Don't handle all the...

9 years ago
Reply
RE: cheap batteries-why don't I listen to my own advice

I check the voltage on some of my batteries and the ones that are getting weak will have a lower voltage after a charge than the others. I put a red d...

9 years ago
Reply
RE: Winter Wear

I just received two dozen of these:At $4.00 per dozen, they are disposable when dirty. I doubt they would work for you in Idaho but you could wear som...

9 years ago
Reply
RE: Anyone using this R10 case?

Drilldo, post: 454303, member: 8604 wrote: Stumbled on this today. Looks pretty neat and sure would beat lugging three cases up the stairs at the mote...

9 years ago
Topic
Replies: 2
Views: 817
Reply
RE: Are you a twenty-percenter?

David Livingstone, post: 451545, member: 431 wrote: Reminds me of a quiz where it seems like you are doing math. Its not writen down but you tell it ...

9 years ago
Reply
RE: In-house site calibration...

If their control points are correct in relation to each other, then the only way they could be off when you shoot them would be if you were using a vr...

9 years ago
Reply
RE: Ivy

My preferred treatment for poison ivy is table salt. Wet the rash area and sprinkle salt on it. Rub it in until it makes a paste, you may have to add ...

9 years ago
Reply
RE: Trimble SPS series total stations

We borrowed one for a couple of weeks, couldn't get it to work with Trimble Access, had to use SCS900.I was not the one setting it up. It may have bee...

9 years ago
Reply
RE: WGS84...Again

I just finished moving all my corners 3 feet, it took months! And now you are telling me that in 5 years I will have to move them all AGAIN? :scream: ...

9 years ago
Page 27 / 87