RE: Line labels disappearingDo you ever copy labels and paste them along a different line and edit them?

You might consider going into your line/curve table defaults and making sure "Automatic Table Updates" is checked off. I would also lock the lot layer...

Written specifically for Client educationGoogle Books PreviewA little more than the average client would want to know. Probably a useful resource for ...

But are all of the elevations on the same datum?

I'm surprised that the elevation is stamped to the hundredth.Many of the older BM's in my area are stamped to the nearest foot with revised published ...

Sounds to me like there is a project or development that they or their parents oppose. I'm assuming it is OK to grab one of the kids and whale on thei...

Not sure if you are using the ACU w/Survey Controller software, but I put this together years ago as a cheat sheet. The back side had a map indicating...

To meet Trimble's distance/angle requirements, I could find only 1 location in my town that was high enough (radio station tower).I can only do the co...

I once found a 1917 GLO brass cap under the road bed. We had gotten a faint signal at the exact search location. I dug a 5" dia. hole in the AC and pr...

I don't have time to figure it out, but it should be fairly easy to create a .bat file that would execute a simple directory listing sorted however yo...

Shhh don't let anyone know but....Hmm... 176 lbs, I doubt that a UAV will be toting that gear around.

No problem for hard surfaces. Rough graded dirt ?? No.

Depending on what container your pouring into, I have found that they are more prone to spilling than the old style (if carefully used).

For those wondering why not to carry over the shoulder..because they cost half your salary and they are made as light and as cheap as possible and thu...

What do they teach these guys in school?There should be a common project coordinate system. They should be able to provide something other than a digi...

Ya, it had orange spray paint on it, the rubber connection covers were missing, the pads where the bracket clamps to the rod were jacked up.That was t...