The over-exposed plat PRM reminds me of the mowers' markers (SRD monuments) found along Florida's Turnpike in your county.

Thanks for the information!

The RTK position of the section corner was 0.47 feet off from the calculated position. The traverse position was off by about 6 feet.

I didn't explain the traverse correctly. The RTK control was not 100 feet apart. Actually, it was about 200 feet apart. The second leg was about 100 f...

Where can I find Chuck Rushton's SPC50 program? How does your custom map closure program work?

We were traversing to find and locate a calculated point. I don't understand your second question. Are you asking me if we started the traverse from t...

If it were up to me, I would always double angles when running a traverse.

Traversing Backward In CADThanks for replying!

Thanks for replying!

The traverse was open-ended. The office calculated the position of the section corner. It was not part of our traverse. I believe there were 5 travers...

The position of the closing monument has not been verified by my company. If I understand you correctly, your method works to detect a blunder at one ...

Thanks for replying!

We used the last foresight as a backsight for the return traverse.

After cutting line for a few hours I was wondering why we just didn't wander out there with a compass. There was nothing to locate along the way. We h...

Yeah, at one traverse point I was standing on a patch of grass. I watched the plate bubble float from side to side as I gently shifted my weight from ...

Sorry Kent! Not trying to contradict you. Got too eager. Tried to remove my last post, but couldn't.

I have a silly question. Why use the coordinates generated by the SET 3C's onboard COGO program? Maybe those coordinates are proprietary to the magnet...

Thanks for your advice! How would I get the right scale factors?

Thanks for your advice! We're using a range pole and a bipod.