A colleague was able to resolve this issue using the "VisualCppRedist AIO" utility: Hope this helps someone facing the same situation.
Thanks everyone for the ideas. The LIDAR-lite v3 seems the way to go. It's made by Garmin, so it should be reliable: SparkFun put together a hookup ...
This issue is detailed in?ÿTopcon Service Bulletin #039: FGN
The Facebook page is more up-to-date:
GeeOddMike, post: 413595, member: 677 wrote: Some more details on this issue see: ftp://igscb.jpl.nasa.gov/pub/resource/pubs/06_darmstadt/IGS%20Presen...
GeeOddMike, post: 374694, member: 677 wrote: While the controversy over who is the father of GPS continues, surveyors and geodesists should acknowledg...
I've checked the slant-to-vertical height results and they seem fine.Cable attenuation loss would affect the power not the phase of L1/L2 differently....
u-blox's own RTK is DD-RTK.Reach-RS uses a less expensive non-RTK u-blox chip and relies on RTKLIB for DD-RTK.
there's a related reply in another thread:
This presentation "Using and Understanding OPUS" says:"OPUSÛS modeling highlights: International Earth Rotation Service (IERS) 2003 solid Earth tide...
Automotive GPS with dead-reckoning is getting bigger and bigger. It uses the car's odometer via ODBII and extra sensors (barometer, gyroscope, etc.)S...
"First look at Android N GNSS raw measurements"
JaRo, post: 384706, member: 292 wrote: there is also a newer one, 77971, that would probably also fall into the same group but I haven't heard that fo...
The IGS would also probably prefer that the antenna identification code is not the same even for minor changes.-FGN.
That's a question I ask myself every time when I see folks using a tall bamboo stick to put the GPS above the tree canopy. RTK say it's good to a cm,...
Apparently the ntrip caster is only available in the Android version of rtklib, and as an experimental feature. So you could try using a smartphone i...
With a dedicated PC, you could use a free ntrip caster such as Lefebure, SNIP, or the one built in RTKLIB.FGN.John Hamilton, post: 381823, member: 640...
So after manually changing the base station coordinates (e.g., via point properties), just click in the menu Process > [Re]Compute coordinates. It ...
