Wilson, give me your email address and I will send you a couple of examples. I've been doing a lot of these lately.

Jeff, It may be due to the point hierarchies that TBC uses. (Ex. Control, Survey, Mapping, Unknown). Try adjusting the GPS data to a lower hierarchy t...

Adam P, post: 410129, member: 10824 wrote: Our pole is cracking due to the attachment for the controller. If you tighten it so the controller doesn't ...

Thank You everyone for the suggestions. I gave it a go this morning and it looks like this will be a huge time saver.

$425 + Matching $25 as well

I will bid $350

I used AutoCAD Revit Structure for a project a few years ago. I started with working through all the product tutorials and watching Youtube videos. It...

Thank You, this is exactly what we need.

> sincpac add on can do thisI checked their website and I can't seem to find anything where it would let you assign the version of C3D you want.

This is what I use, found it on the autodesk C3D message board. Its easier to select all points and renumber to a higher starting number then renumber...

Thank you everyone for the help. I ran the collimation adjustment along with turning off autolock when taking shots on the BS and ended up getting muc...

This is what I came up withIf I had to do it again I would make the spaces for tripods a little larger. Its a tight fit to get them in. I'll have to t...

I should probably run a test using just my 360 mult track prism as the FS and BS and see if the vertical error comes down. If that's the case then it ...

> Bad backsight HI for 2nd setup?I've thought that, I've tried multiple people reading the height and adjusting for tape slope with no luck. I shou...

> > Need a little help figuring out this problem. > > > > The scenario> > > > 1. S6 with BS approximately 800 feet away....