VCUKentucky3

I've actually done quite a bit of this, but usually it's just comparing DTMs. I think that's the way to go here, and forget the shot records. When t...

Good QuestionLast I heard in the next couple of years, possibly this year. Depends on funding.I drove thru there this morning eastbound and didn't se...

Try scaling the DOT points using the correct scale factor from 0,0. In Ky, they give SPC and project control coordinates. The project control coordi...

Saw this in a deed the other day. It references an original city plat made in 1901.Block on plat had lots 9-16, all 192x48, like this, 16' alley down...

Judging from your past posts, your attention to detail may cause you some heartburn with a robot. From my standpoint, using the proper methods, they ...

Now there's something you don't hear every day......"codswallop you may scream"

What is the tolerance for the job? The $1m could be + or -, I'd think it would average out.

Don't know that I've ever needed to actually label a line in plan view with a slope distance. I can see why that might not work, given that it is a 2...

To get slope distance, just change the units settings from horizontal to slope.If you want to enter slope distances, just put an S in front of the dis...

With every upgrade there has been a way to open older files. When it went from ver 5 to ver 6, there was a 5to6.exe program to open then save. I bel...