If he typed it on a phone, that was probably the result of auto-INcorrect.?ÿ It gets me every time I don't go back and review the message before sendi...

Let's look at Montana, an International foot state according to a list I found.?ÿ Unfortunately the really high ones I looked were all VERTCON, so not...

That is not a high enough point to see the difference in the two kinds of feet.?ÿ As noted in the quote above, it takes at least 5000 ft to show the d...

While various states use one kind of foot or the other for horizontal, I expect most just use the NGS data sheets to define elevations, which as Loyal...

I appreciate the good words posted above about me, but I think you are being more impressed than is warranted. I probably wouldn't be a good crew memb...

The line shown in my plot seems to fall near a region of transition on the picture Loyal posted, but it isn't on the steepest part. I think I found th...

When I get home I'll plot these on the picture you posted, but eyeballing it I think I see that my line is about on a sharp transition from red to blu...

With a geoid slope of 2 cm per km and an elevation less than 300 meters, the offset in paths is 0.6 cm and the height correction is entirely negligibl...

Because most lending institutions immediately resell the mortgages, it's not just a local matter.?ÿ They want them to have no red flags for other inst...

.... between elevations 55.5 feet, and 67.5 feet relative to [whatever base]

Looks like a lot of found corners, so a re-survey isn't going to help. Lots of elements of AP here.?ÿ But it isn't AP until you pay a l*wy*r a ton of ...

I reworded it to allow for either and added 2 cites to including the handles.?ÿ I'd still like to find a better citation.

I reverted that edit, but that person put it back with a reference citation.?ÿ I still doubt his conclusion is generally true.?ÿ Does anyone have more...

I got a 9-hour session on that disk.?ÿ Rapid solution pk-pk values: ellip ht 8 mm, lat 4 mm, lon 8 mm.?ÿ?ÿ So I don't think the tree hurt much. But no...

I'm not very knowledgeable on tractor models.?ÿ Here's a better view.