And why is that?  It would seem they could lack perspective on their own case and be better served by someone independent, but I don't see anythi...

I eyeball between the marks, whether it's 1/16", 0.01 ft, or 1 mm marks. But it's a principle of woodworking that dimensions are rarely critical: 1/1...

Gates was darned near selling the bridge when he sold DOS to IBM. He rented furniture and hired people off the street for a few days to look busy for...

I'm currently doing a minor woodworking project and chose to design it in millimeters. It's a musical instrument stand (for my wife's hammered dulcime...

Like the coach, you will be suspected of bias.?ÿ If you sued a judge would you trust them to hear the case??ÿ

What instrument??ÿ There may be differences in what is user-adjustable. Did you have accurate temperature and pressure settings??ÿ If not, then the re...

>over $150K sitting in an "overpaid" account. We have addressed this with them on numerous occasions to no avail. Apparently it would cost them mor...

He posted several times on this forum just two weeks ago.

All meridians form right angles with the tangent to each parallel of latitude.

Great approach.  I did something like this only more extreme one time.  My brother wondered what he was seeing on the horizon several miles...

We had a long discussion of this when NGS talked about it in a webinar.

It is important to think about?ÿ which tolerances need to be tight.?ÿ Nobody is going to get excited if the foundation is .04 ft further from the boun...

I tried to fit a curve to lots 1,2, 3, and part of 4 in order to learn more about that part of lot4.  I find the radius to be a bit more than 400...

Board of Registration report for each and every?ÿ map that doesn't meet minimum standards in your state. I'd forgive an occasional lapse, but if that'...